Hot searches: Anchor Bolt ProcurementAnchor Bolt factoriesWedge Anchor BoltAnchor Bolt wholesale

Comprehensive technical materials are available
Current location: Home » News Center » Company News » An example of a turned part with and without an undercut

An example of a turned part with and without an undercut

Categories: Company NewsStars: 3StarsVisit: -Release time: 2014-08-29 19:05:00
 Font size:【 Large Middle Small

On turned parts an undercut is also known as a neck. They are often used at the end of the threaded portion of a shaft or screw to provide clearance for the cutting tool, and also referred to as thread relief in this context. A rule of thumb is that the undercut should be at least 1.5 threads long and the diameter should be at least 0.015 in (0.38 mm) smaller than the minor diameter of the thread. Strictly speaking the relief simply needs to be equal or slightly smaller than the minor diameter of the thread. Thread relief can also be internal on a bore, and then the relief needs to be larger than the major thread diameter. They are also often used on shafts that have diameter changes so that a mating part can seat against the shoulder. If an undercut is not provided there is always a small radius left behind even if a sharp corner is intended. These types of undercuts are called out on technical drawings by stating the width and either the depth or the diameter of the bottom of the neck.

{$site_name$} Prudential Industrial Group We provide you with hign-quality and hign-strength anchor bolt with strong technical support.

Newsletter
Contact Info

AddressAddress: Room502,No.799,YinXiang Road,NanXiang,JiaDing,ShangHai,China.

TelephoneTelephone: +86-21-69923201

>E-mailE-mail: postmaster@ukprd.net

Copyright
Prudential Industry (Shanghai) International Trade Co.,LTD.

HOME | ABOUT US | CONTACT US | NEWS CENTER | PRIVACY STATEMENT| Sitemap Google Analytics